Env2midi
From Mdspedia
This article is a stub. You can help by expanding it
Have a look at the Livecut article for some guidelines.
Once the article article is documented enough, remove the {{stub}} line.
Contents |
Introduction
This plugin analyses the incoming audio signal to extract its envelope which is converted into MIDI continuous controler. I should add parameters to change the size of the analysis window and the type of enveloppe detection.
Parameters
FAQ, troobleshootings
hi, i use this plug with energyXT to control the drive of tube simulation like TLs saturated driver or antares tube with the guitar dry signal and it bring lot of natural compression (I think it is the key for a real good tube simulation but not for clean effect cause of noise generated by gain variation, or maybe with a smoother change of the gain)! But now, I would like to do the same with my amp sim pedal board (witch doesn’t make noise with midi CC gain control), but i can’t find on which channel this plug send midi CC! could you help me?
nota: if you need someone to test beta version of this plug, just tell me!
